U.S. flag An official website of the United States government

On Oct. 1, 2024, the FDA began implementing a reorganization impacting many parts of the agency. We are in the process of updating FDA.gov content to reflect these changes.

U.S. Food and Drug Administration
  1. Home
  2. Inspections, Compliance, Enforcement, and Criminal Investigations
  3. Inspection References
  4. Inspection Guides
  5. Electromagnetic Compatibility Aspects of Medical Device Quality Systems
  1. Inspection Guides

Electromagnetic Compatibility Aspects of Medical Device Quality Systems

[Table Of Contents] [Next Page]

GUIDE TO INSPECTIONS OF ELECTROMAGNETIC 

COMPATIBILITY ASPECTS OF MEDICAL DEVICE

QUALITY SYSTEMS

TABLE OF CONTENTS

Page Title Page Number
Introduction Pg 1
Electromagnetic Compatibility Pg 2
IEC 60601-1-2 Pg 2
EMC in GMP Inspections Pg 3
Design Controls Pg 3
Device Labeling Content Pg 5
Purchasing Controls Pg 6
Inspection, Measuring & Test Equip Pg 6
Production/Process Controls Pg 7
Handling/Storage Pg 7
Device Master Record Pg 7
Complaint Files Pg 7
Servicing Pg 8
Corrective/Preventive Action Pg 9
Recalls/Upgrades Pg 11
Inspection Reports/Observations Pg 12
Appendix A Pg 13
Appendix B Pg 14
Appendix C Pg 15
Appendix D Pg 16
Appendix E Pg 17

INTRODUCTION

This guide was prepared by the FDA, Office of Regulatory Affairs, and the Center for Devices and Radiological Health (CDRH), Office of Compliance.

This guide provides FDA investigators with information regarding electromagnetic compatibility (EMC) and how it is likely to be addressed in a medical device firm's Quality System/Good Manufacturing Practices (QS/GMP) (21 CFR Part 820). Terms throughout this document that are in bold typeface are defined in Appendix A.

THIS DOCUMENT APPLIES ONLY TO ELECTRICALLY POWERED (MAINS OR BATTERY) DEVICES. It includes information on the following:

  1. electromagnetic disturbances (EMD), including radiated and conducted emissions, as well as electrostatic discharge (ESD);
  2. electromagnetic interference (EMI), susceptibility and immunity;
  3. international and voluntary EMCstandards, such as IEC 60601-1-2; (these are not FDA performance standards or mandatory requirements.)
  4. areas of the new Quality System regulations where EMC is likely to be addressed;
  5. how the regulations apply to EMCissues in continuing production of existing devices, design and production of new or modified devices, and upgrades and recalls of marketed devices; and
  6. expectations and limitations of the GMP inspection process regarding EMC.

The Center for Devices and Radiological Health (CDRH) is encouraging firms, many of whom have never considered some of these issues, to begin the process of addressing EMC. The goal is to improve the industry norm, not to penalize industry efforts to design EMC into their devices. There are a number of confounding factors in achieving EMC. Manufacturers can design EMCinto their electrical devices for most expected use environments, depending on design options for proper functioning or electrical safety, intensity or variableness of environments, the

[Table Of Contents] [Next Page]

Return to: Page Top | Inspection Start

Back to Top