The 8 hours of initial training related to FFDM should include practical (hands-on) training in any aspects of the use of such systems in the medical physicist’s area of responsibility that are unique to the FFDM system (such as FFDM QC testing to be performed by the medical physicist). The remainder of the 8 hours, if any, can be didactic or practical training related to any aspect of FFDM. The instruction must be provided by a qualified instructor. Such training can also be counted towards the medical physicist’s continuing education requirement.
FDA strongly recommends that medical physicists whose 8 hours of FFDM training did not include any training in QC tests related to soft copy interpretation, obtain such practical training under a qualified instructor before beginning to independently perform such tests.
For other changes that can occur in the field, such as introduction of a new quality control manual by the manufacturer or the introduction of a new model of a FFDM unit, the same general principle as described above should be followed. If the new manual or model introduces new unique features to an FFDM system that fall into the medical physicist’s area of responsibility, practical training under a qualified instructor on those features should be included in the training of any medical physicist who has not already met the 8 hour requirement. Medical physicists who have previously met this requirement should also receive training in the new unique features under a qualified instructor before beginning to evaluate them independently. Such training can also be counted towards the medical physicist’s continuing education requirement.