• Decrease font size
  • Return font size to normal
  • Increase font size
U.S. Department of Health and Human Services

Medical Devices

  • Print
  • Share
  • E-mail

Pneumatic Tourniquet Cuffs, with the Tourniquet Systems

Article reprinted from Medical Product Safety (MedSun) News, Volume 7, Issue 1 (January 2007), p. 24
Device Description:

The pneumatic tourniquet system consists of a pressure regulated control unit, tubing and an inflatable tourniquet cuff. The cuffs inflate with air, oxygen or nitrogen to a preset pressure to compress the patient’s blood vessels during surgical procedures, thus ensuring a bloodless operative field. Qualified medical professionals, such as a surgeon or anesthetist, use the tourniquet systems. They are contraindicated for use in neonates, patients with peripheral vascular disease, thrombosis, or embolism. Both disposable and reusable tourniquets cuffs are available. Disposable cuffs are intended for single-use only and reusable cuffs are intended to be cleaned and inspected prior to their multi-use.

Crinkling, folding and bending of pneumatic tourniquet cuffs are common occurrences whether it is a disposable single-use tourniquet, or one that was intended for multiple uses.

Reported Incident:

A patient undergoing a total knee replacement had a pneumatic tourniquet cuff in use. Cast padding was applied to the patient’s upper thigh, beneath the tourniquet cuff, prior to the patient being covered with a surgical drape. During the surgical procedure, the patient’s bleeding became uncontrolled and the pressure of the tourniquet cuff was inflated to 300mmHG, and then to 350mmHG. The inflation source appeared to be working properly, without any active alarms. At the end of the surgical procedure, the drapes were removed and the tourniquet cuff was noted to be crinkled and appeared to have a defect on the inside. The cuff’s rigid bladder was bent, folded and crushed down the wrong way, thus preventing the appropriate pressures from being applied to the thigh and controlling the patient’s blood flow. The patient experienced subsequent blood loss as a result of this event.

Recommended Actions:
All Pneumatic Tourniquet Cuffs
  • Tourniquet Cuffs are subject to wear, tear and deterioration and should be inspected routinely for integrity and potential safety hazards, prior to each use. The pneumatic cuff’s velcro cuff closures, bladder, seams and tubing should be inspected before applying the cuff to the patient. Physical damage to the cuff, such as rips, tears or holes, as well as, kinked or occluded tubing connecting the cuff to the instrument ,may prevent the instrument from displaying the correct pressures .
  • Tourniquet control units and cuffs should be checked, disassembled and cleaned in accordance with the manufacturer’s written instructions with documentation per internal policy.
  • Caution should be taken with the placement of tourniquet cuffs. The cuffs should be applied smoothly, with no wrinkles or tunneling effect to prevent damage to the underlying skin and soft tissue. The skin should be protected by wrapping padding, with interlocking fibers that will not come apart, prior to tourniquet application.
  • Inflation pressure and times are to be determined by the patient’s physician. It is important to remember that when a patient is experiencing uncontrolled bleeding at the operative site, increasing the pressure might not be the most appropriate action. Attention should be given to the tourniquet cuff to see if anything looks unusual, such as the crinkled cuff in this case.
References:

AORN (February 2002). Recommended Practices for Use of the Pneumatic Tourniquet. AORN Journal. 75 (2).

McEwen J., Inkpen K. (August 2002). Safety Preventing Skin Injuries. The Surgical Technologist. 218 (1):7-14.

Tourniquets.org Web Site.

Food and Drug Administration (April 2001). Enforcement of FDA Requirements on Reprocessing of Single Use Devices