Cosmetics

Prohibited & Restricted Ingredients

Regulations prohibit or restrict the use of some substances in cosmetics because of safety or environmental factors.

Except for color additives that are not coal-tar hair dyes, cosmetic ingredients are not required to undergo premarket approval by FDA. However, violating the restrictions on the use of the substances listed below may cause FDA to pursue regulatory action.


What ingredients are prohibited by regulation?

Regulations specifically prohibit or restrict the use of the following ingredients in cosmetics. For complete details, refer to the regulations (21 CFR, Parts 250.250 and 700.11 through 700.35).

  • Bithionol. The use of bithionol is prohibited because it may cause photo-contact sensitization (21 CFR 700.11).
  • Chlorofluorocarbon propellants. The use of chlorofluorocarbon propellants (fully halogenated chlorofluoroalkanes) in cosmetic aerosol products intended for domestic consumption is prohibited (21 CFR 700.23).
  • Chloroform. The use of chloroform in cosmetic products is prohibited because of its animal carcinogenicity and likely hazard to human health. The regulation makes an exception for residual amounts from its use as a processing solvent during manufacture, or as a byproduct from the synthesis of an ingredient (21 CFR 700.18).
  • Halogenated salicylanilides (di-, tri-, metabromsalan and tetrachlorosalicylanilide). These are prohibited in cosmetic products because they may cause photocontact sensitization (21 CFR 700.15).
  • Methylene chloride. The use of this substance in cosmetic products is prohibited because of its animal carcinogenicity and likely hazard to human health (21 CFR 700.19).
  • Vinyl chloride. The use of vinyl chloride is prohibited as an ingredient of aerosol products, because of its carcinogenicity [21 CFR 700.14].
  • Zirconium-containing complexes. The use of zirconium-containing complexes in aerosol cosmetic products is prohibited because of their toxic effect on lungs, including the formation of granulomas [21 CFR 700.16].
  • Prohibited cattle materials. To protect against bovine spongiform encephalopathy (BSE), also known as "mad cow disease," cosmetics may not be manufactured from, processed with, or otherwise contain, prohibited cattle materials. These materials include specified risk materials*, material from nonambulatory cattle, material from cattle not inspected and passed, or mechanically separated beef. Prohibited cattle materials do not include tallow that contains no more than 0.15 percent insoluble impurities, tallow derivatives, and hides and hide-derived products, and milk and milk products.** [21 CFR 700.27, as amended].

back to top

What cosmetic ingredients are restricted by regulation?

Some ingredients may be used in cosmetics, but only under the restrictions stated in the regulations:

  • Hexachlorophene. Because of its toxic effect and ability to penetrate human skin, hexachlorophene (HCP) may be used only when an alternative preservative has not been shown to be as effective. The HCP concentration of the cosmetic may not exceed 0.1 percent. HCP may not be used in cosmetics that in normal use may be applied to mucous membranes, such as the lips [21 CFR 250.250].
  • Mercury compounds. Mercury compounds are readily absorbed through the skin on topical application and tend to accumulate in the body. They may cause allergic reactions, skin irritation, or neurotoxic manifestations. The use of mercury compounds as cosmetic ingredients is limited to eye area cosmetics at concentrations not exceeding 65 parts per million (0.0065 percent) of mercury calculated as the metal (about 100 ppm or 0.01 percent phenylmercuric acetate or nitrate) and is permitted only if no other effective and safe preservative is available for use. All other cosmetics containing mercury are adulterated and subject to regulatory action unless it occurs in a trace amount of less than 1 part per million (0.0001 percent) calculated as the metal and its presence is unavoidable under conditions of good manufacturing practice [21 CFR 700.13].
  • Sunscreens in cosmetics. Use of the term "sunscreen" or similar sun protection terminology in a product's labeling generally causes the product to be subject to regulation as a drug. However, sunscreen ingredients may also be used in some products for nontherapeutic, nonphysiologic uses (for example, as a color additive or to protect the color of the product). To avoid consumer misunderstanding, if a cosmetic product contains a sunscreen ingredient and uses the term "sunscreen" or similar sun protection terminology anywhere in its labeling, the term must be qualified, in accordance with 21 CFR 700.35(b), by describing the benefit to the cosmetic product provided by the sunscreen ingredient (for example, "Contains a sunscreen to protect product color."). Otherwise, the product may be subject to regulation as a drug [21 CFR 700.35]. For further information on sunscreens, refer to Tanning Products.

back to top

Are these the only ingredients that can cause a product to be in violation of the law?

No. A product may become adulterated or misbranded in a number of ways. Among these are improperly used color additives or any ingredient, other than a coal-tar hair dye, that causes a cosmetic to be harmful under customary or usual conditions of use, or causes a cosmetic to become misbranded, as stated in the Federal Food, Drug, and Cosmetic Act, Sections 601 and 602. Additionally, an ingredient having a history of use in or as a cosmetic may at any time have its safety brought into question by new information.

More Resources


* "Specified risk material" means the brain, skull, eyes, trigeminal ganglia, spinal cord, vertebral column (excluding the vertebrae of the tail, the transverse processes of the thoracic and lumbar vertebrae, and the wings of the sacrum), and dorsal root ganglia of cattle 30 months and older and the tonsils and distal ileum of the small intestine of all cattle.

** Tallow must be produced from tissues that are not prohibited cattle materials or must contain not more than 0.15 percent insoluble impurities as determined by the method entitled "Insoluble Impurities" (AOCS Official Method Ca 3a-46), American Oil Chemists' Society (AOCS), 5th Edition, 1997, incorporated by reference in accordance with 5 U.S.C. 552(a) and 1 CFR part 51, or another method equivalent in accuracy, precision, and sensitivity to AOCS Official Method Ca 3a-46. You may obtain copies of the method from AOCS Exit Disclaimer, 2211 W. Bradley Ave. Champaign, IL 61821.

back to top

June 22, 1996; Updated May 30, 2000. This document is current. It is updated only as needed.

 

Page Last Updated: 05/07/2014
Note: If you need help accessing information in different file formats, see Instructions for Downloading Viewers and Players.